I have used ICCAVR for a number of years without getting to an issue that could not be resolved,Įspecially with access to. So thanks for you guys comments and help, I am beginning to question my ability to get this done. Out and get avr-gcc and CodeBlocks to run on this Linux box.
Reluctant to do that as I am now just in the hobby mode. I have started thinking of using the CrossWorks IDE which I think runs on Linux. The build-essential file(s) and I was not clear if that was actually required. I will mention again, I have never installed
#CODEBLOCKS COMPILER NOT WORKING SOFTWARE#
The only way to remove installed software is either use the Ubuntu Software center or See if I can determine where if the proper files are located. I am still learning to use Linux (Ubuntu) and I will use the command line utility 'find' and
So far, I have not found what I would expect to be the revelent help (.h) and include files. My problems are in the setup and defining the proper path setup which apparently I have I am sure this can work because so many others seem to have used it on Linux machines.
#CODEBLOCKS COMPILER NOT WORKING INSTALL#
Question(s): Would I be better to re-install everything and perhaps install 'build-essential first'? Generates the startup file (main.c) which has “#include †at the head of the file.īTW I did install the avr-gcc from the Atmel web page. I must be setup in one fashion, if I start a new AVR project, then CodeBlocks Tried the changes mentioned by snigelen and there was no change, same identical error.Ĭlawson: I don't have any idea on the status of the CodeBlock and AVR-GCC software setupĪt this point in time.
0 kommentar(er)
